Futaba S130 Standard Servo  [S130]

This is the Futaba S130 tiny, double-ball-bearing ,water-tight and dust-tight Servo

Abiut the Futaba S130 servo

AboutS130 servo The S130 is small, double-ball-bearing water-tight and dust-tight servos created adn manufactured for use with Futaba radio control sets. The FP-S130 is for Futaba J, M and SG Series. Use them for channel expansion or as replacement components.

FEATURES:

• High Quality five-pole micromotor water-tight and Dust-tight servos. Output torque: 55.6oz.in (4kg.cm). Nominal running rate : 0.24sec/60 level
• Brand new indirect drive sealed potentiometer improces vibrateion and surprise opposition, and increases basic precision tremendously.
• Futaba low-power customized IC supplied high starting torque, slim dead musical organization, and exceptional trackability
• Fiberglass reinforced PBT injection molded serco situation is mechanically strong and invulnerable to glow fuel.
• Strong polyacetal resin precision serco gear features smooth procedure , positive basic , and without any backlash.

SPECS:

• Control system : + pules width control 1520us basic
• Operation angle : One side 45degree min (including trim)
• Power : 4.0-6.0v distributed to the receiver
• Current drain : 6.0v 8mA (at idle)
• Production Torque: 55.6oz.in (4kg.cm)
• Operating rate : 0.24sec/60 level
• Measurements : 38.5 x 19.5 x 34.5mm