3Racing CY-12S/SG Front SSG Graphite Shock Tower for Hot Bodies Cyclone Sport Version  [CY-12S/SG]

Front shock tower for Cyclone Sport

This front SSG graphite shock tower is an RC-scale replacement part produced by 3Racing for the Hot Bodies Cyclone Sport Version chassis. It is presented as a direct-component intended to match the mounting pattern and layout used on that Cyclone variant, allowing you to swap the front tower while keeping standard suspension components in place.

From a tuning perspective the part serves the basic roles of locating the front dampers and affecting suspension geometry under load. Using a graphite tower can change flex characteristics compared with plastic alternatives, so expect differences in steering feedback and small‑bump response that matter when adjusting camber, toe or roll centre with your existing shock positions.

Installation follows common RC practices: remove the stock tower, align the mounting holes, and secure with the original hardware. Because hardware inclusion is not specified here, confirm whether mounting screws are supplied before assuming replacement of existing fasteners.