3Racing CY-26/F Aluminium Front Stabilizer for Hot Bodies Cyclone Sport and Racing Versions  [CY-26/F]

Front stabilizer for Cyclone

This aluminium front stabilizer is an RC-scale upgrade designed to fit Hot Bodies Cyclone Sport and Racing versions. It serves as a straightforward replacement or upgrade for the factory front anti-roll component, intended to change front-end roll stiffness and refine weight transfer during turns.

Made from machined aluminium, the part focuses on adding predictable stiffness ahead of the suspension to influence understeer/oversteer balance without altering suspension geometry. It is intended for 1/10 electric on-road setups and track practice where small changes to front roll resistance help tune steering response and tyre load distribution.

Installation is basic: swap the stock stabilizer for this unit using the existing mounting points on the Cyclone front chassis. No special tools beyond standard hex drivers are required; check screw torque and alignment after fitment. After installation, confirm free suspension travel and re-check swaybar end-link lengths if adjustable on your chassis.

Tuning notes: increasing front stabilizer stiffness generally reduces roll and can make turn-in feel quicker while potentially increasing understeer at high speed; reducing stiffness yields more front compliance and can help with turn bite on low-traction surfaces. Make small incremental changes and test on the same track conditions to evaluate effect.