3Racing M4WD-16 Tamiya 1/32 Mini 4WD carbon multi-roller flat plate for front/rear/side stays  [M4WD-16]

3Racing M4WD-16 carbon multi-roller flat plate for Mini 4WD stays

This 3Racing carbon multi-roller flat plate is a third-party replacement designed for compatibility with Tamiya Mini 4WD models. Constructed from carbon material, the plate provides a rigid mounting platform for multiple rollers and stay configurations used on Mini 4WD front, rear, or side stays. The description that follows is editorial and aimed at experienced hobbyists and collectors familiar with Mini 4WD setups.

Design notes: the flat plate form factor keeps rollers in a single plane and helps control lateral movement without adding a stacked stay assembly. Because the part is a carbon accessory, consider its stiffness relative to stock plastic stays; carbon can alter handling characteristics when installed on performance-oriented chassis such as Super-II, MA, MS, AR, FM-A, VS, and Super-II derivatives. Confirm compatibility with your chosen stay posts and mounting hardware before final fitting.

Installation considerations: verify hole spacing and fastener lengths on your vehicle, use appropriate washers or spacers to prevent point loading on bearings or rollers, and test rotation clearance for each roller position. For collectors fitting display models, the carbon finish offers a clean, low-profile look; for active builders, pairing with suitable rollers and dampers is common practice.

Care and maintenance: carbon accessories are durable but can delaminate if overly stressed; avoid using excessive torque on mounting screws and inspect for edge damage after circuit use. Clean with a soft brush and avoid harsh solvents that can degrade adhesives or surface finishes on attached components.