3Racing M4WD-35/RE Double aluminum rollers for Mini 4WD, 16-17mm (red) - roller set  [M4WD-35/RE]

Tamiya Mini 4WD Double Aluminum Rollers ( 16-17mm )(Red) - 3RACING M4WD-35/RE
Price:
USD$7.50
Brand:
3Racing
Model:
M4WD-35/RE
Condition:
Brand New
Write a review

3Racing M4WD-35/RE double 16-17mm aluminum rollers in red

The M4WD-35/RE double aluminum rollers are a compact spare aimed at experienced Mini 4WD hobbyists and collectors who keep a parts inventory. The set uses a stacked roller form factor in anodized red aluminum and is sized for 16-17mm roller positions commonly found on accessory stays and mass damper mounts.

In editorial terms, these rollers are a material and fitment option rather than a tuning component. Notes to consider when evaluating a purchase: check your existing roller shaft diameter and spacer arrangement before fitting, and confirm whether your roller mount requires bearings or bushings that are not included.

Finish and machining are the primary attributes described for this part. The anodized surface provides corrosion resistance and a consistent color match for red-themed builds, while the aluminum body keeps individual roller mass low compared with some heavier aftermarket alternatives.

What roller bore diameter is typical for this part and what axle does it accept

The product listing specifies 16-17mm roller size. Confirm your roller shaft diameter and whether you use 3mm shafts or spacers; this part is sold as the aluminum roller bodies only and may require separate pins or bushings.

Are bearings included with the rollers

The listing refers to aluminum roller bodies and an anodized finish. Bearings or bushings are typically not included with this type of spare; check the seller notes for contents before purchase.

Will these rollers fit standard roller stays and mass dampers

The 16-17mm diameter targets common stay apertures. Fitment depends on your stay hole spacing and whether you use spacers or special pins; verify mounting dimensions before installation.

How should I maintain these aluminum rollers

Keep the anodized surfaces free of grit and inspect bore edges for wear. Light cleaning and periodic inspection are sufficient for parts stored or used occasionally.

Are there color or size variants available from the same maker

Manufacturers often offer multiple anodized colors and sizes; consult the parts catalog or seller page for compatible 14mm, 15mm, or 18mm options and alternate finishes.

Is this part appropriate for display models as a visual upgrade

Yes. The anodized red finish and machined appearance make these rollers suitable as visible spare parts on display builds, provided the fitment matches your display setup.

Copyright © 2008-2026 rcjaz.com All rights reserved