3Racing SAK-D6808A/BU Aluminum Rear Bulkhead Belt for Auper D6  [SAK-D6808A/BU]

Aluminum rear bulkhead belt for Auper D6

This aluminum rear bulkhead belt is an RC-scale replacement part designed for the Auper D6 chassis. The component serves at the rear bulkhead area to control belt routing and provide a rigid mounting surface where the belt crosses the bulkhead, maintaining alignment under load.

Compatibility is focused on Auper D6 platform layouts that use a rear bulkhead belt arrangement. The part is supplied in a blue finish and is intended as a direct-fit hop-up where the original bulkhead belt is removable or serviceable within the kit design.

Installation typically follows the kit's standard rear bulkhead access procedures and uses existing mounting interfaces; check your Auper D6 kit manual for fastener locations and torque recommendations. As a tuning element, the aluminum belt plate helps reduce flex at the belt pass and can contribute to consistent drivetrain behavior during high-load cornering and acceleration on track surfaces.

Use this machined aluminum rear bulkhead belt to replace or upgrade the stock rear belt pass on Auper D6 kits where increased rigidity and repeatable belt alignment are desired for competitive RC setup tuning.