This aluminum ARS linkage mount is a direct replacement part designed for use with the Auper D6 RC touring chassis. It reuses the chassis' existing linkage locations and provides a machined mounting surface in red anodized finish to replace the stock plastic bracket.
Functionally, the ARS linkage mount offers alternative mounting points that let you refine linkage geometry and roll response without changing major suspension components. By switching to the aluminum mount you gain a firmer reference point for link connections, which helps maintain alignment under load and supports consistent setup changes during tuning sessions.
Installation is straightforward: remove the original mount, position the aluminum piece in the same location, and secure it using the kit's existing hardware. After fitment, confirm link lengths and ball-end alignment at full droop and full bump to ensure no binding or unintended preload is present.
Use notes: this is an RC-scale spare intended for chassis setup and handling adjustments; it is suitable for hobbyists refining linkage settings on 1/10 touring car builds that use the Auper D6 mounting pattern.
Copyright © 2008-2026 rcjaz.com All rights reserved
