3Racing SAK-D6809/RE Aluminum Belt Drivetrain Shaft for Auper D6, red anodized aluminum upgrade part  [SAK-D6809/RE]

Aluminum Belt Drivetrain Shaft

This is an RC-scale replacement shaft designed for belt-driven Auper D6 kits. The component is machined from aluminum and finished with a red anodized surface to provide a durable, serviceable part for drivetrain assemblies. It serves as a direct swap for the original shaft where the Auper D6 layout uses a belt-driven transmission.

In typical installation the shaft locates through the chassis mounts and interfaces with the belt and pulleys; check belt alignment, pulley seating, and set screw engagement during fitment. The part is intended to support routine setup work and tuning adjustments on track or during bench maintenance without implying performance gains beyond proper assembly and alignment.

Use this shaft when replacing worn drivetrain hardware or when assembling an Auper D6 kit to ensure correct belt routing and reliable mechanical fit; inspect mating components and bearings when installing.