3Racing Zero Cero Rear Lower Suspension Arm by Factory Pro O-3CP016R  [FP-O-3CP016R]

Rear lower suspension arm for Zero Cero

This is a single rear lower suspension arm designed as an aftermarket replacement for the 3Racing Zero Cero chassis, supplied by Factory Pro under model O-3CP016R. It is an RC-scale component intended to restore or replace the original rear lower arm and to serve as a straightforward part for routine maintenance or setup adjustments.

In practical terms the arm locates the rear hub relative to the chassis and affects camber and toe response under load, so it plays a direct role in suspension geometry and handling balance. Use it where the original arm is worn, damaged, or when a like-for-like replacement is required for setup repeatability.

Installation is typical for rear lower arms on touring-style 1/10 scale chassis: remove the wheel and hub carrier as needed, swap the arm while retaining factory pins and hardware, then check alignment and free movement of the suspension. No special tools are required beyond standard hobby hex drivers and pliers.

Compatibility: Intended for 3Racing Zero Cero chassis, rear lower arm position only, sold as 1 pcs.