This is an RC-scale upgrade part designed for ARRMA platforms, providing a direct aluminum replacement for factory plastic servo mounts and horn hardware. The kit uses 7075 aluminum where noted to improve part stiffness and simplify removal during maintenance, and it ships with a pre-installed 25T servo horn plus a 23T servo saver steering tube for replacement options.
The servo horn has a built-in spring to help absorb shock and reduce peak load on the servo output, helping protect the servo under heavy impacts common in off-road running. Threadlocker is not applied at the factory so you can fit or swap the 23T steering tube before locking fasteners; apply threadlocker after final assembly to prevent loosening during use.
Installation notes: confirm spline compatibility with your chosen servo and use the supplied grade 12.9 screws and stainless shims as required to set proper preload and alignment. The part is intended to support chassis setup and tuning by making servo removal and replacement easier while keeping steering geometry consistent.
Use this alloy mount and horn set when you need a direct aluminum replacement for plastic steering components on supported ARRMA models, fit the supplied parts, apply threadlocker, and verify spline and alignment during setup.
Copyright © 2008-2026 rcjaz.com All rights reserved