Arrowmax am-210032 Silicone Diff Fluid 59ml 200.000cst for RC differential tuning  [am-210032]

Arrowmax Silicone Diff Fluid 59ml 200.000cst
Price:
USD$0.00
Brand:
Arrowmax
Model:
am-210032
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Silicone diff fluid for RC differentials

This Arrowmax silicone diff fluid is an RC-scale accessory intended to alter differential behavior by changing internal damping. The 59ml bottle offers a concentrated supply of high-viscosity fluid that is used inside gear-type and ball-based differentials to influence how torque transfers between wheels.

In practice the 200.000cst viscosity increases the fluid coupling effect inside the diff, slowing relative motion between side gears and affecting traction and rotation bias. Model tuners use heavier diff fluids to stabilise throttle bite and mid-corner rotation, or to reduce inside-wheel spin during acceleration on low-grip surfaces.

Installation is a routine maintenance and tuning task on RC cars: drain the old fluid from the diff housing, inspect internal gears and bearings, then introduce the new silicone oil through the fill or pinion opening following the chassis maker's service steps. Operate the diff through its range after filling to eliminate air pockets and confirm consistent damping.

Because viscosity directly changes handling balance, swap one axle at a time when testing so you can evaluate front-to-rear differences, and keep a log of viscosities tried and observed effects. Store the bottle upright and cap it after use to keep the fluid free of dirt and evaporation.

Higher centistoke values increase internal damping, slowing gear relative motion and producing stronger coupling between wheels, which affects traction and cornering feel.
Remove the diff from the chassis if needed, open the housing, drain old fluid, clean internal parts, then refill with new silicone oil and operate the diff to remove air before reassembling.
Replace when performance changes, after heavy running, or if contamination is suspected; keep a simple maintenance schedule based on running hours and observed handling.

Copyright © 2008-2026 rcjaz.com All rights reserved