Arrowmax am-429393 Ball Driver Hex Wrench .093 (3/32) x 110mm Limited Edition  [am-429393]

Ball-end Hex Driver for RC

This Arrowmax am-429393 ball driver is an RC-scale hand tool sized for .093 (3/32) hex fasteners with a 110mm shaft length and a ball-end tip for angled access. The design intent is to give a consistent engagement on 3/32 hex screws used on model assemblies, letting you reach recessed or angled fasteners without altering the screw seating angle during routine maintenance or setup.

Use the driver when you need controlled torque for tightening or loosening small hex screws around chassis components, servo mounts, suspension parts, and bearing retainers. The ball-end profile helps when access is limited or when a slight offset angle is required to clear surrounding parts during adjustments.

Practical handling notes: work with the tip aligned to the screw as much as possible to avoid rounding, keep fasteners clean, and perform final torque checks by feel to ensure consistent assembly when tuning or repairing RC models.