Arrowmax am-700601 LiPo 5200mAh 3S Battery with Deans Connector  [am-700601]

Arrowmax AM Lipo 5200mAh 3S - 11.1V 55C Continuous 110C Burst wire with Deans
Price:
USD$0.00
Brand:
Arrowmax
Model:
am-700601
Write a review

Arrowmax 3S 5200mAh LiPo overview

This Arrowmax am-700601 battery is a 3S LiPo pack designed as an RC-scale power source for electric models. It pairs a 5200mAh capacity with Deans plug termination and a focused discharge rating to support sustained high-current demands typical of brushless setups and high-performance ESCs.

Installation notes: use a purpose-built LiPo balance charger, verify proper balance lead connection, and secure the pack with straps or a foam cradle to limit movement and protect wiring. Route the Deans lead to avoid sharp bends and keep the terminal away from contact with chassis hardware that could abrade insulation.

Tuning role: capacity affects run time and weight distribution while discharge rating affects throttle response under load. When comparing packs for setup changes, keep cell count and connector type consistent, then vary capacity or C-rating to refine runtime versus peak power tradeoffs without altering motor gearing or ESC timing.

Maintenance and safety: store at recommended storage voltage, inspect pouches and wiring before each session, and always use an appropriate LiPo-safe charging bag for unattended charging. Replace the pack if swelling, torn pouches, or damaged leads are observed.

For hobbyists seeking a reliable 5200mAh 3S pack with Deans termination, this Arrowmax unit is a straightforward choice for standard and competitive RC driving where consistent high-discharge performance and simple installation are priorities.

Use a 3S LiPo compatible balance charger and connect the balance plug to the charger balance port each time you charge.
Yes, swapping connectors is possible but should be done with proper soldering skills and heat shrink to maintain reliable connections and insulation.
Higher continuous and burst C-ratings provide cleaner voltage under heavy load which helps sustained high throttle runs and reduces voltage sag in powerful setups.
Store at about 3.8V per cell, in a cool dry place, and disconnect from the model to prevent parasitic drains that can damage the cells.

Copyright © 2008-2026 rcjaz.com All rights reserved