Arrowmax AM-950043 Battery Holder Set For AM Honeycomb Chassis  [AM-950043]

Battery holder set for AM Honeycomb Chassis

This Arrowmax AM-950043 battery holder set is an RC-scale accessory intended to secure battery packs on the AM Honeycomb Chassis. The content below stays technical and practical, focusing on how this part fits into chassis layout, what to check during installation, and how it affects balance and tuning without overstating performance.

Compatibility is explicit in the product name: the holder is designed for the AM Honeycomb Chassis layout, so confirm mounting points and battery dimensions before fitting. Typical checks include verifying screw hole alignment with the chassis bosses, ensuring the battery sits flush to the chassis surface, and confirming clearance for leads and connectors to avoid interference with other components like the ESC or servo.

Installation is straightforward for standard chassis builders: position the holder over the designated battery tray area, align the mounting holes, and tighten hardware progressively to maintain even pressure. Use the existing chassis mounting points; if alignment requires minor adjustment, re-check battery centring and secure the pack before final torqueing. This part functions as a mounting interface affecting battery placement and therefore chassis balance and weight distribution during setup.

For tuning considerations, small shifts in battery position alter the centre of gravity and can influence handling. Use this holder to fine-tune fore-aft placement and left-right centring during setup cycles. When swapping battery types or capacities, re-check fit and secure mounting to prevent movement under load.

This Arrowmax AM-950043 battery holder set is a dedicated RC accessory for the AM Honeycomb Chassis that serves as a mounting interface to stabilise battery placement and support chassis tuning efforts; verify fitment before final installation.