XRAY T4'20 Aluminium Front Lower 1-Piece Suspension Holder by Arrowmax AM-T4-302723  [AM-T4-302723]

Front lower suspension holder for T4'20

This Arrowmax aluminium front lower 1-piece suspension holder replaces the stock multi-piece assembly with a single machined unit aimed at chassis builders who need consistent mounting points for suspension links and shock geometry. The part is identified by model number AM-T4-302723 and is produced to match the XRAY T4'20 layout.

Use this holder when you want a rigid, repeatable anchor for lower suspension components during setup sessions. It locates the lower arm and link placements used in front and rear tuning, so adjustments to camber, toe and roll center can be carried out without introducing variance from a worn or flexible mount.

Installation is straightforward for mechanics familiar with T4'20 maintenance: remove the stock lower holder, install the Arrowmax unit in the same mounting points, and verify link lengths and shock positions before final tightening. Because the component is a single-piece aluminium unit, pay attention to torque and thread locking to avoid over-stressing fasteners.

This Arrowmax holder is intended as a direct-replacement upgrade for XRAY T4'20 setups where a single-piece aluminium lower mounting point is preferred for consistent suspension behavior during tuning.