Awesomatix A12X Body Holder X Graphite 2.0mm by Factory Pro O-ACPP03  [FP-O-ACPP03]

Body holder for A12X chassis

This Factory Pro produced-for part is an RC-scale body holder designed specifically for the Awesomatix A12X chassis, supplied as a single pair for body retention on 1/10 electric touring setups. The component uses 2.0mm graphite to provide a firmer mounting contact compared with typical plastic clips while remaining lightweight.

Compatibility and role: the holder X secures the polycarbonate body to the A12X mounting points and is intended to improve repeatability when removing and remounting the body during setup or track testing. Its primary role is mechanical positioning rather than aerodynamic modification.

Installation and tuning notes: fit the pair to the existing A12X body mount posts using the original hardware and verify symmetry on both sides before final tightening. Check body alignment and wheel clearance after installation, and use the holders as a baseline when experimenting with ride height or body shim adjustments to keep repeatable body position between runs.