Awesomatix A12X Bumper Plate 2.5mm Graphite by Factory Pro O-ACPP04  [FP-O-ACPP04]

Bumper plate for A12X

This Factory Pro aftermarket bumper plate is an RC-scale spare designed for the Awesomatix A12X platform, supplied under the model O-ACPP04 by Factory Pro. Made for hobbyists who need a direct replacement or a dedicated part for front-end bump stop tuning, the plate is described as 2.5mm graphite and intended to maintain bumper geometry during impacts and setup changes.

Compatibility is focused on the A12X chassis family, and the plate serves as a tuned support between bumper mounts and chassis components to control travel and contact points. As an RC accessory, it is intended for model-scale use only and not for any real vehicle application.

Installation is straightforward for experienced builders: remove the original bumper plate, verify hole alignment with the A12X bumper mounts, and fasten with the existing hardware. Check that the plate sits flush and does not bind adjacent steering or suspension linkages. Small adjustments to bumper spacing can alter contact timing and front-end feedback during impacts.

Tuning role: use the graphite plate when you want a thin, stable contact surface that resists compression and preserves mounting geometry, helping to keep repeatable bumper behavior across practice runs and quick part changes at the track.