Axial AX10 Deadbolt Aluminum Shock Set by JAZRIDER AX10-24000-OR  [AX10-24000-OR]

Aluminum shocks for AX10 Deadbolt

This is an RC-scale aluminum shock set produced by JAZRIDER for the Axial AX10 Deadbolt platform, finished in orange. The set replaces standard shock bodies with machined aluminum components intended for hobby use on AX10 Deadbolt chassis, keeping all references at model scale.

The parts serve as direct-replacement shock bodies and mounting components where original shock internals (springs, pistons, shock oil) can be retained or serviced as part of routine tuning. The aluminum construction provides a stiffer housing compared with typical plastic bodies and helps with repeatable setup when adjusting spring preload and oil damping during on-vehicle tuning.

Installation is straightforward for typical AX10 maintenance: disassemble the existing shocks, transfer or service internal components as needed, and install the aluminum bodies in the original shock locations. Basic hand tools such as hex drivers are normally used for removal and reassembly; keep original seals and shafts inspected to avoid leaks after swapping housings.

Tuning notes: this set does not change the fundamental tuning variables used on AX10 Deadbolt models — springs, piston types, and oil viscosity remain the primary damping controls. Use the aluminum bodies to achieve consistent stroke and to reduce body deformation when experimenting with different spring rates and oil grades on scale crawling or trail setups.