This is an RC-scale aluminum steering linkage designed for the Axial AX10 Deadbolt chassis, finished in orange. The part replaces the stock steering link to offer a direct metal connection between steering knuckles and the servo horn area, intended for scale RC steering maintenance and tuning tasks.
Compatibility is limited to the Axial AX10 Deadbolt platform as stated in the product name, and no other models are claimed. The component is intended as a drop-in steering linkage replacement for hobbyists maintaining or fine-tuning AX10 Deadbolt rigs.
Installation notes: inspect thread engagement and end-link seating when fitting this aluminum linkage to existing steering components. Ensure ball ends or rod ends seat properly into the steering knuckles and that tie-rod lengths are adjusted for neutral toe and steering centring. Avoid over-tightening fasteners to prevent stripping mating threads in plastic knuckles.
Tuning role: use this linkage to stabilise steering geometry during trials or scale crawling runs, and to maintain consistent servo feedback when adjusting servo endpoints or steering throw. The rigid aluminum construction reduces flex compared with stock plastic links, which can aid repeatable steering response during setup changes.
Maintenance: check for wear at ball joints or rod ends and confirm the orange finish for any surface damage after impact events. Replace if ball sockets show excessive play to preserve steering accuracy.
Copyright © 2008-2026 rcjaz.com All rights reserved
