Axial AX10 Deadbolt Front Offset Axle Link Mount by JAZRIDER AX10-24013-OR  [AX10-24013-OR]

Front Offset Axle Link Mount

This is a scale RC front offset axle link mount designed for the Axial AX10 Deadbolt platform, produced under JAZRIDER model AX10-24013-OR. The part relocates the front link connection point outward relative to the axle centerline to alter steering and suspension response while keeping installation straightforward for typical AX10 Deadbolt setups.

Manufactured from aluminum, the mount adds rigidity to the link pickup area compared with many stock plastic pieces, which helps maintain link geometry under load and during low-speed technical maneuvers. It is presented as an upgrade component intended for RC-scale rock crawling and off-road tuning where predictable axle behavior matters.

Installation notes: the mount replaces the stock front link mount and uses existing fastener locations on the AX10 Deadbolt axle housing. After fitting, verify link angles and wheel clearance through full suspension travel and adjust link lengths or pivot spacing as needed to achieve the desired roll centre and steering feel. Regularly check fastener torque after initial runs.