AXIAL AX10 Scorpion Chassis 28mm Brushless Motor Plate by 3Racing AX10-16  [AX10-16]

Motor plate for AX10 Scorpion

This motor plate is an RC-scale accessory intended for the AX10 Scorpion chassis to accept 28mm brushless motors. It serves as a fixed mounting surface that locates the motor relative to the spur gear and pinion, helping to establish repeatable gear mesh and secure motor placement within the chassis layout.

Installation is a bench-fit process: set the motor in place and check pinion-to-spur engagement before fully tightening fasteners. Confirm clearance to nearby components such as the servo and ESC and make small positional adjustments or shims as needed to achieve quiet, consistent mesh. Use compatible screws and confirm thread engagement with the chassis mounting points.

In tuning terms, this plate lets you control motor offset and alignment without altering gearbox components. Small changes in motor position influence gear noise and thermal loading, so verify mesh under load and after short test runs rather than relying on a single static measurement.