This aluminum C hub carrier is produced as an RC-scale replacement part intended for Axial AX10 Deadbolt platforms, offering a metal alternative to stock plastic carriers. It is designed to maintain the original mounting points and fit the Deadbolt-style steering knuckle geometry without requiring chassis modification.
Installation notes: the carrier replaces the factory C hub and is fitted using the existing wheel hex and axle arrangement on AX10 Deadbolt models. Use the same fasteners and verify pin alignment before final torqueing to avoid binding. No special tools are required beyond standard hex drivers and a setup stand for wheel alignment checks.
Tuning role: switching to an aluminum carrier increases steering stiffness and provides a firmer pivot for the wheel assembly, which helps maintain predictable steering feedback during aggressive off-road runs and when adjusting caster or toe. It is typically used by builders who want a metal-to-metal mounting surface for repeatable geometry under load.
Copyright © 2008-2026 rcjaz.com All rights reserved
