Axial Racing EXO Alloy Front Toe Block - 2pcs by GPM EX008  [EX008]

Axial EXO front toe block overview

This is an RC-scale front toe block made for the Axial Racing EXO platform, supplied as 2 pcs. The component is machined from aluminium alloy to offer greater local stiffness compared with stock plastic parts. As a chassis-level hop-up, it serves the steering geometry by holding the front toe link pivot and allowing finer toe adjustments during setup and tuning.

The part is intended for model-level use on EXO chassis configurations and is presented without additional hardware. Expect the toe block to be used where durability and repeatable toe settings are priorities, such as scale off-road or short-course setups where consistent steering feel matters.

Installation and tuning notes: check the mounting points on your EXO chassis for matching hole spacing and orientation before fitting, verify thread engagement on existing fasteners, and use it as part of incremental changes when adjusting toe for handling balance.