AXIAL Racing RR10 Bomber Front & Rear Main Drive Shaft by GPM RR237SA  [RR237SA]

Adjustable steel + 6061 T aluminium drive shaft

This pair of adjustable main drive shafts is designed for the AXIAL Racing RR10 Bomber platform and supplied by GPM as part number RR237SA. Each shaft combines steel retention hardware with an aluminium 6061 T body to balance strength and weight for RC-scale drivetrain use.

The design uses a steel wire ring to secure fasteners in place, reducing the chance of screws backing out under vibration. One shaft series is adjustable between 147mm and 157mm while the other covers 122mm to 130mm, matching front and rear length requirements commonly encountered during chassis setup.

Intended role and tuning advice: these shafts serve as direct replacements or upgrades for damaged or worn stock pieces and can be used to fine-tune driveline geometry when adjusting ride height or suspension travel. Check joint fit and runout after installation, and use thread-lock where specified by your chassis manual.

If you need durable, lightweight replacement drive shafts for RR10 Bomber setups, this GPM RR237SA two-piece set offers adjustable lengths and secure retention hardware to keep your RC drivetrain running reliably.