Axial Racing RR10 Bomber/Yeti/Wraith Bevel Gear by GPM RR1200S  [RR1200S]

Steel Bevel Gear for Axial RR10 Platforms

This GPM RR1200S replacement is a pair of steel front/rear bevel gears designed for Axial platforms listed as compatible. Supplied as 2 pcs, the item matches the original function of bevel gears inside the axle and gearbox assembly, offering a direct swap where steel construction is preferred over stock material.

Use this part when replacing worn bevels or when preparing a drivetrain for heavier loads in scale crawling or trail use. It is intended as an RC-scale component for the RR10 Bomber, Yeti, and Wraith platforms, and focuses on the mechanical role of bevel gears: transmitting torque between driven and driving shafts at right angles within the axle/gearbox.

Installation notes: remove the axle or gearbox cover to access the bevel set, inspect mating gears and bearings for wear before fitting, ensure correct tooth mesh and axial alignment, and replenish appropriate lubricant after assembly. After installation, verify smooth rotation under free spin before first full-power runs.

A straightforward steel replacement set for Axial RR10-based drivelines where durability and wear resistance are required, supplied as two pcs for front/rear applications.