Axial Racing SCX10 Alloy Hex Adapter (14mmx9mm) by GPM AX010/14X9MM  [AX010/14X9MM]

Alloy hex adapter for Axial SCX10

This is an RC-scale hex adapter set designed for Axial Racing platforms, supplied as a 4pcs set. The AX010/14X9MM adapters convert wheel mounting interfaces to a 14mmx9mm hex pattern and are offered by GPM for use on Axial Racing EXO, SCX10, and Wraith models.

Functionally these adapters serve as the interface between wheel hubs and wheels, keeping wheel position and alignment consistent when fitting aftermarket wheels or changing hub offsets. The part is described as alloy, and intended for model-level wheel mounting on scale crawlers and trail rigs.

Installation notes: confirm hex engagement and seat the adapter fully against the hub before tightening. Use the correct sized hex driver for the wheel hex screw, check for play after initial run, and re-torque after short testing laps. If your setup uses threadlocker on wheel fasteners, follow your usual RC maintenance practice.

Tuning role: these adapters are a low-profile way to adjust wheel fitment and track width in small increments, useful when swapping beadlock or aftermarket wheels to achieve clearance or stance goals on Axial Racing EXO, SCX10, and Wraith chassis.