AXIAL Racing SCX10 Aluminium Chassis Lift Combo (77→87mm) by GPM SCXH87  [SCXH87]

Aluminium chassis lift for SCX10

This 62pcs aluminium lift combo for the AXIAL Racing SCX10 platform raises chassis ground clearance from 77mm to 87mm to increase crawling angles on technical rock terrain. The kit combines aluminium collars with stainless steel fasteners and consumables to form a plug-and-play upgrade that focuses on fit, measured link lengths, and basic geometry changes rather than cosmetic alteration.

Design highlights kept from source details:

• Ground clearance increase: 77mm → 87mm, providing an extra 10mm of lift to the chassis.
• Main shaft change: stock CVD head replaced by a universal swing shaft cross head to allow larger steering and suspension articulation angles.
• Damping and link adjustability: multiple damper plate holes accept different damper positions to tune static ride height and axle attitude.
• Measured link lengths: front upper midpoint 130mm, front lower midpoint 130mm, rear lower midpoint 140mm, to match supplied components and reduce mid-install trimming.
• Adjustable main shaft ranges as provided: long main shaft 125mm–140mm, short main shaft 130mm–145mm.

Included hardware is supplied as a single 62pcs set with stainless steel button head screws, aluminium collars, O-rings, screw shafts, and T-lock nuts prepared for immediate assembly. The vendor reports that tie rods were measured to avoid binding during crawling, so check pre-measured lengths before final tightening and verify steering centring after installation.

This GPM SCXH87 lift combo is a focused chassis-height and steering-geometry accessory for AXIAL SCX10 scale crawlers, intended for hobbyists tuning clearance and articulation on rocky or technical trails.