AXIAL Racing SCX10 Front and Rear Main Drive Shaft F:123mm-133mm R:118mm-128mm by GPM SCX037SA  [SCX037SA]

Front and rear main drive shaft for SCX10

This GPM replacement set supplies a front and rear main drive shaft pair intended for AXIAL Racing SCX10 scale crawlers. Each shaft combines steel and aluminium elements to balance wear resistance at the spline interfaces with reduced rotating mass where appropriate, and the set is offered as two pcs for front and rear use.

Lengths are specified to fit typical SCX10 drive layouts, listed as front 123mm–133mm and rear 118mm–128mm. These shafts serve the drivetrain role of transferring torque from the gearbox to the axles, affecting driveline stiffness and endplay. When replacing stock shafts, verify spline engagement and alignment to avoid binding and premature wear.

Use this pair when you need direct replacements that match SCX10 front and rear length ranges, and when you want a mix of steel and aluminium in the rotating drivetrain components.