This aluminum rear lower chassis linkage is specified at 130mm and finished in gunmetal, built as an RC-scale replacement part for the Axial Racing SCX-10 Honcho. It is intended to sit in the rear lower linkage position of the SCX-10 Honcho chassis to provide a metal alternative for that mounting point while keeping the original geometry and wheelbase length defined by 130mm.
In practical terms this part is used during setup and tuning to stabilise rear-end behaviour and maintain consistent linkage length under load. Its aluminum construction offers predictable flex characteristics compared with softer materials, which helps when making incremental adjustments to suspension feel and chassis response during scale crawling sessions.
Installation is straightforward for users familiar with SCX-10 Honcho rear link mounts, as the component is designed to fit the same rear lower attachment points on that chassis. Use existing mounting hardware from the vehicle, verify alignment at full suspension travel, and check for clearance with nearby components before final tightening.
Copyright © 2008-2026 rcjaz.com All rights reserved
