This brass front/rear gearbox cover is an aftermarket replacement designed for AXIAL Racing SCX10 II scale crawlers and related chassis that accept the same cover profile. Fabricated from brass, the part serves two functions on RC models: it protects differential gears in the front or rear gearbox area and provides additional ballast to tune vehicle balance.
The cover is machined to sit close to bearing surfaces to reduce play around the differential assembly, which helps steady gear engagement under low-speed crawling loads. A dedicated oil-fill opening is included in the design to simplify lubrication or gear lube top-ups without full disassembly.
Installation uses the included stainless steel cap head screws and follows normal gearbox access procedures for the SCX10 II platform. The part’s measured mass is noted in the original information as 35 grams, so plan weight distribution and suspension tuning accordingly if ballast effects are a concern.
AX31384
Use this brass cover when you need added protection for differential gears and a measured ballast effect on AXIAL SCX10 II builds, and verify screw fit and bearing clearance during installation.
Copyright © 2008-2026 rcjaz.com All rights reserved
