AXIAL SCX10 II Adjustable Main Shaft with Alloy Body by GPM SSCX2037FRSA  [SSCX2037FRSA]

Adjustable main shaft for SCX10 II

This is an RC-scale replacement main shaft set produced by GPM for AXIAL SCX10 II chassis. The assembly combines an aluminum alloy shaft body with hardened steel universal swing shafts to reduce rotating mass while keeping the cross-head wear points durable under crawling loads.

The universal swing shaft cross-head layout increases achievable steering angles and wheel articulation compared with some stock shafts, which helps improve low-speed obstacle negotiation. The set includes white silicone O-rings positioned to separate the shaft head from the alloy body and a pinned head detail to resist loosening during repeated suspension travel.

Measured adjustable axle ranges are provided as build reference: front adjustable length 100-110mm, rear adjustable length 130-140mm. Use these ranges to verify fit before final installation, and confirm pin and screw torque to prevent play.

Use this set as a direct replacement or upgrade where increased steering angle and articulation are required. Check axle length and verify fastener security during setup, and pair with suitable drive shafts and bearings for reliable low-speed crawling performance.