AXIAL Racing SCX10 III JEEP JT GLADIATOR Steel+Aluminium Front+Rear CVD Drive Shaft by GPM SCX3L037SA  [SCX3L037SA]

Axial SCX10 III JT CVD drive shafts

This is an RC-scale front and rear CVD drive shaft set intended for AXIAL Racing SCX10 III JEEP JT GLADIATOR models. The components use a mixed-material approach combining alloy 6061 T6 and steel to balance torsional strength with reasonable mass for scale crawling applications. The CVD swing joint design maintains consistent power transmission under suspension articulation typical of 1/10 scale rock crawlers.

Installation notes: these shafts replace standard dogbones or brittle plastic pieces and install at the axles and transmission outputs where CVDs are used. Basic fitment requires axle hex clearance and retention with supplied screw pins. Use thread locker sparingly on steel fasteners as needed and verify rotational clearance through the suspension travel before final tightening.

Tuning role: upgrading to mixed alloy/steel CVDs improves durability against high torque inputs from modified motors or aggressive crawler setups, and it reduces driveline lash for smoother low-speed control. For further drivetrain reliability check splines, wave shims, and existing bearings when upgrading.

This GPM-produced CVD drive shaft set is a practical upgrade for AXIAL SCX10 III JEEP JT GLADIATOR scale crawlers seeking greater driveline durability and consistent power transfer; confirm fit before final assembly.