AXIAL Racing SCX10 Steel+Aluminium Front & Rear Main Drive Shaft (F:117mm-127mm,R:122mm-132mm) by GPM SCX037SAA  [SCX037SAA]

Front & rear main drive shaft for SCX10

This is a replacement main drive shaft pair designed for AXIAL Racing SCX10 scale crawler use. The assembly combines steel and aluminium components to balance torsional strength and weight where the drivetrain requires both rigidity and reduced rotating mass.

The set covers the stated center-to-center ranges without implying fit beyond the SCX10 designation: front shafts sized for 117mm–127mm and rear shafts sized for 122mm–132mm. Check your axle and gearbox mounting distances before installation to confirm one of these ranges matches your chassis configuration.

Installation notes: inspect and service related bearings and hex fittings before fitting the shafts, verify spline engagement with the spur and axle gears, and torque fasteners to the values recommended by your chassis manufacturer. These shafts are intended to restore or upgrade drivetrain geometry and durability rather than change vehicle behaviour dramatically.

Use these shafts when replacing worn driveline components or adjusting your SCX10 driveline lengths; confirm dimensional fit before final assembly and check overall driveline alignment after installation.