This brass front steering knuckle set is an RC-scale replacement part made for use with the Axial SCX24 chassis. It replaces the stock steering knuckles with a heavier metal option intended to alter front-end dynamics and provide a different steering feel during low-speed technical runs.
Installation is intended for hobbyists familiar with basic model teardown: remove the wheel and hub assembly, detach the stock knuckle, transfer any bearings or wheel hexes as needed, and fit the brass knuckle using the vehicle's existing fasteners. A set of common hex drivers is sufficient, and no extra machining or special tools are required for standard SCX24 setups.
From a tuning perspective, brass knuckles change front axle inertia and can improve steering feedback on slow-speed rock crawling or scale trail sections where added nose weight helps wheel traction and tracking. They also offer a metal replacement option for those aiming to test different weight and handling balances without altering springs or dampers.
Copyright © 2008-2026 rcjaz.com All rights reserved
