AXIAL Racing SMT10 Aluminium Wheel Hex (+2mm) by GPM MJ0102/+2MM  [MJ0102/+2MM]

Aluminium wheel hex for SMT10

This is an RC-scale aluminium wheel hex produced for the AXIAL Racing SMT10 platform, supplied as a 2pcs set with a +2mm offset to alter track width without changing wheel backspacing. The part is intended for hobby use on model cars and for tuning wheel position and handling characteristics on the SMT10 chassis.

Design and role: the hex modifies the wheel mounting stance to allow small changes to track width for setup or clearance needs. Being machined aluminium, it offers firmer wheel retention compared with typical plastic hexes and helps maintain alignment under load from model-scale driving and course demands.

Installation notes: replace the stock wheel hex with these aluminium units using the existing axle and wheel hardware on SMT10 setups. Check fitment clearance for tyres and suspension travel after fitting a +2mm offset, and hand-tighten then torque to the usual wheel hardware practice for your model. No real vehicle use intended.

Included hardware: the package supplies the wheel hexes plus the small fitting parts commonly needed during installation, listed here for clarity: 2pcs wheel hex, 2x10.9 steel pin - 2pcs, 2x7 steel pin - 2pcs, 2.5x2.5 screw shaft - 4pcs, 1.2 hex socket key - 1pc.