Axial Racing Wraith Aluminum C Hub Carrier by JAZRIDER AW-23012-S  [AW-23012-S]

This is an aluminum C hub carrier made for the Axial Racing Wraith line, finished in silver and supplied as an RC-scale replacement or upgrade part. It serves as the steering knuckle mount on the front suspension, offering a metal alternative to common plastic hubs used on scale off-road rigs.

The component is intended for Wraith chassis fitment as indicated by the product name. As a direct replacement style part, it keeps the same mounting points and wheel hex orientation used on Wraith setups while changing the hub material to aluminum for increased wear resistance in demanding trail or rock-crawling sessions.

Installation notes: confirm left and right orientation before tightening, transfer or reuse the original hardware where appropriate, and verify free rotation of the hub and wheel after fitting. Adjust toe and steering limits as needed on your transmitter and linkage to maintain intended handling characteristics.

Maintenance and tuning: inspect fasteners for loosening after early runs, check for binding at the knuckle and axle interface, and replace or service associated bearings or pins as part of routine upkeep. The aluminum carrier may slightly alter feedback compared with plastic hubs, so fine-tune steering and suspension settings if you change component material.