This is an RC-scale aluminum upper linkage set designed for Axial-based crawler chassis. The red anodized links come as a 4pcs pack and replace standard plastic link arms to increase rigidity in the upper suspension link positions. The components are intended to work with the listed Axial chassis platforms and to serve as a direct hop-up for fine-tuning suspension geometry, roll center, and long-term wear resistance.
Installation notes: these links mount in the upper link positions of the specified Axial chassis and use the existing ball ends or mount points on stock link mounts. When fitting, verify ball-end spacing and thread engagement on the existing hardware, and check suspension travel through the range of motion before finalizing.
Use these links to achieve a firmer upper link on crawler setups where increased lateral stiffness and reduced flex are desired; check fitment against your chassis before committing them to hard runs.
Copyright © 2008-2026 rcjaz.com All rights reserved
