Axial Racing Yeti 2.2 Wheel Hub Adapters 22mm Thickness by GPM YT022C  [YT022C]

2.2 wheel hub adapters for Axial Yeti

This aluminium wheel hub adapter set is an RC-scale part intended to change the wheel offset on 2.2" wheel setups. Supplied as a 1pr set, the adapters increase the lateral spacing between wheel and hub to alter track width and wheel stance without modifying hubs or axle assemblies.

The adapters are described as aluminium and 22mm thick in platform terms, and they serve as a straightforward hop-up for fine tuning handling balance and clearance on rock racer and crawler layouts. Fitment and handling effects will vary by tyre, wheel backspacing, and suspension setup, so check wheel-to-shock and wheel-to-link clearances before use.

Installation is a basic hub swap: remove the wheel, detach the stock hub or wheel hex as applicable, fit the adapter to the hub or axle per your chassis layout, then refit wheel hardware and verify rotational clearance and hex engagement. Use correct hex screws and verify bearing alignment after fitting to avoid binding.