Axial Racing Yeti Aluminium Adjustable Servo Tie Rod by GPM YT024A  [YT024A]

Adjustable servo tie rod for Axial Yeti

This is an RC-scale adjustable servo tie rod designed for the Axial Racing Yeti platform, sold as 1 pcs. The part combines an aluminium threaded rod with black plastic end fittings to form a compact steering link intended for use on model rock racers.

Functionally the tie rod replaces the servo-to-knuckle linkage and serves as a tuning item for steering geometry. Adjusting the threaded section changes toe and steering throw in small increments, allowing setup changes without altering other suspension parts.

Installation is straightforward on compatible Yeti steering setups: remove the existing link, match left- and right-hand threading if applicable, and ensure adequate thread engagement on both ends. Check that the plastic end fittings seat securely on the linkage pins and that the rod clears suspension travel through the full range.

Notes for maintenance and tuning: inspect plastic ends for wear after heavy use, confirm straight alignment after installation, and verify there is no binding through full steering travel. Use common RC practice for tightening and rechecking fasteners after a test run.