Axial Racing Yeti Aluminium Rear Cage Mount by GPM YT311A  [YT311A]

Aluminium rear cage mount for Yeti

This aluminium rear cage mount is an aftermarket replacement part produced by GPM for the Axial Racing Yeti platform, designed to restore or strengthen the rear cage mounting points on the RC rock racer. The part serves as a direct-fit upgrade where the chassis and mounting bushings match the Yeti cage geometry.

The component's role is structural: it provides a rigid interface between the rear cage and the chassis rails to reduce movement under load and keep body mounts aligned during hard runs. Using aluminium improves wear resistance compared with typical plastic mounts, and helps maintain alignment after impacts without implying any full-scale vehicle use.

Installation is straightforward for experienced hobbyists: remove the existing rear cage mount hardware, test-fit the aluminium piece to verify hole alignment, then secure using the original screws or matching fasteners. Check thread engagement and use thread locker if consistent with your usual maintenance practice. No specialized tools beyond common hex drivers are required for trial fitting and final tightening.

For tuning, this mount is useful when you need repeatable rear cage location for suspension and body setup changes; it is best used as part of measured adjustments rather than as a substitute for other damaged chassis components.