Axial Racing Yeti Rear sway bar and cage mount by GPM YT312  [YT312]

Rear sway bar mount set for Axial Yeti

This 9pcs set addresses the rear anti-roll linkage and cage attachment points used on Axial Racing Yeti models in RC rock racing applications. The components are an aftermarket aluminium mount and associated wire that relocate or replace factory sway bar and cage anchors to allow controlled rear roll behavior and secure cage tie-in.

The parts are intended for hobby-grade RC chassis work only and are described here as scale components for Axial Yeti vehicles. The set focuses on three roles: providing a rigid mounting point for the rear sway bar, offering a location to fasten cage wiring or supports, and enabling small tuning changes to rear roll resistance without altering suspension geometry.

Installation is performed at existing rear mount points on the Yeti chassis. Typical steps include removing the stock mount hardware, fitting the aluminium mount into the factory position, routing and securing the included wire for cage attachment, and verifying clearances with the suspension travel. Basic hand tools and a hex driver are normally sufficient; precise torqueing and checking for binding after installation are recommended.

The technical intent is adjustment and tuning rather than structural overhaul. Hobbyists use this mount to fine-tune rear anti-roll stiffness and to secure cage connections in trail and rock racing setups, keeping adjustments reversible to restore original configuration if needed.

This aluminium rear sway bar and cage mount set provides a compact aftermarket option for Axial Yeti owners seeking controlled rear roll adjustment and a reliable cage attachment method, while retaining reversible installation and standard tooling requirements.