Axial Racing Yeti Rear Upper Chassis Link Aluminium with Plastic Ends by GPM YT014RP  [YT014RP]

Aluminium rear upper chassis link for Yeti

This is an RC-scale rear upper chassis link designed for use with the Axial Racing Yeti platform, supplied as 1pr. The link uses an aluminium centre section with plastic end fittings to interface with the existing link mounts on the chassis.

Functionally this part replaces the rear upper link assembly and is intended to serve in suspension geometry and handling tuning. It is a straightforward swap: remove the stock rear upper links, transfer any reusable hardware or bearings if needed, and fit the replacement link using the same mounting points. No special adapters are required when installed on an unmodified Yeti chassis.

For setup and maintenance, check link alignment and free movement through the suspension travel, confirm end fittings are secure, and inspect for play at the attachment points after initial runs. Use common RC hand tools to fit or remove the link and retain original torque settings for chassis hardware.