Axial Racing Yeti spring-steel anti-thread tie rod and aluminium servo horn by GPM YT16023  [YT16023]

Aftermarket tie rod & servo horn for Axial Yeti

This GPM aftermarket set is built for Axial Racing Yeti platforms and combines a spring-steel anti-thread tie rod with an aluminium servo horn designed for 23T spline output shafts. As a scale RC accessory, it focuses on steering stability and mechanical reliability without altering core chassis geometry.

The spring-steel tie rod resists deformation under repeated steering loads and helps limit threadback under torque changes, while the aluminium servo horn mates to a 23T spline output shaft to provide a firmer interface between servo and linkage. The parts are supplied as a single set for direct replacement or upgrade on compatible Yeti setups.

Installation notes: confirm the servo output uses a 23T spline before fitting, retain existing mounting hardware where applicable, and check spline engagement and fastener torque after first runs. In tuning terms, this combination is intended to make steering inputs feel crisper and maintain alignment during aggressive cornering without implying changes to motor, ESC, or other drive components.