Axial Racing Yeti / Yeti XL 32 Pitch 17T Steel Pinion Gear by GPM YTL017TS  [YTL017TS]

Pinion Gear for Axial Yeti / Yeti XL

This is a single-piece steel #45 pinion gear specified for 32 pitch systems, supplied as a 1pcs set and intended for Axial Yeti and Yeti XL platforms. It is an RC-scale replacement part designed to mount on the motor pinion shaft to adjust final gear ratio or replace a worn pinion.

Use this pinion when you need a different tooth count to fine-tune acceleration versus top speed, or when restoring proper mesh after wear. When changing pinions, confirm motor shaft fit, align mesh with the spur gear, and check that the motor bearings and gearbox run free. Avoid forcing mesh tightness, ensure a small backlash, and retest under no-load spin before full-power runs.

Material and tooth count are intended to match 32 pitch gear trains; verify compatibility with your existing spur gear and motor shaft size before installation. This part is for RC vehicle use only.