Axial Racing Yeti XL spring-steel steering tie rod by GPM YTL047SP  [YTL047SP]

Axial Racing Yeti XL Spring Steel Steering Tie Rod With Plastic Ball Ends(AX31033) - 1pr set - GPM YTL047SP
Price:
USD$11.90
Brand:
GPM
Model:
YTL047SP
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Steering tie rod for Yeti XL

This steering tie rod is an RC-scale replacement part produced for the Axial Racing Yeti XL platform and listed as AX31033, supplied as a 1 pr set. The rod uses spring-steel as the load-bearing element and terminates in plastic ball ends to allow pivoting at linkage joints without metal-to-metal contact.

Functionally it serves as the steering link between the steering assembly and the steering knuckles, providing a direct connection point for fine adjustments. Spring-steel construction offers elastic recovery under impact loads, helping the link return toward its original shape when subjected to typical off-road bends.

Installation is straightforward: replace the existing tie rod pair with this set, verify ball-end seating and joint movement, and confirm steering geometry after fitting. Inspect the plastic ball ends periodically for wear and replace the set if play develops to maintain accurate steering response.

What is included with the part?

The item is supplied as a 1 pr set intended to replace the pair of steering tie rods on the Yeti XL.

Is this compatible with Axial Yeti XL only?

The product is produced for the Axial Racing Yeti XL platform and is listed as AX31033; use it where that part number applies.

How should I maintain the ball ends?

Periodically check for play and wear, clean debris from the joint, and replace the tie rod set if the plastic ball ends show significant deterioration.

Copyright © 2008-2026 rcjaz.com All rights reserved