This is an RC-scale rear upper chassis linkage designed for the Axial SCX-10 Honcho platform. The part acts as a replacement or upgrade for the rear upper mounting link that locates the chassis and helps control roll and articulation in trail and scale driving situations. The finish is gunmetal and the construction is aluminum as stated in the product name.
Use this linkage when you need a direct-fit rear upper link for SCX-10 Honcho setups, or when tuning rear roll center and suspension geometry. It is intended to work with the existing mounting points on the Honcho chassis without modifying the frame layout.
Installation notes: the linkage replaces the factory rear upper link and is intended to be mounted using the vehicle's original hardware and bushings where applicable. Confirm hole alignment and clearances before final tightening during setup, and verify wheel articulation through the full travel of the suspension after fitting.
Copyright © 2008-2026 rcjaz.com All rights reserved
