AXIAL SCX10 II +3mm Aluminum Hex Hubs with Brake Disk by GPM SCX2010D+3MM  [SCX2010D+3MM]

Technical overview

This is an RC-scale aluminum hex hub set produced for AXIAL SCX10 II platforms, designed to replace standard hubs and shift the wheel track outward by 3mm per side compared with a 5mm reference. The parts combine wheel assemblies with the front and rear wheel shafts to maintain turning smoothness while adding track width for chassis stability.

Key functional notes drawn from the product details:

• Widened track: the design increases hub width to achieve an 8mm offset relative to the original 5mm reference, improving lateral stability for scale crawling and trail running setups.
• Secure mounting: the hub geometry is shaped to hold the wheel hub tightly, intended to reduce play under load and support improved climbing performance.
• Finish and form: modern metallic styling with swirl engraving on the outer ring provides a finished look while remaining an RC-scale accessory.

Included items are listed from the product data, use them as supplied to secure the hubs:

• Brake Disk - 2 pcs
• M4x2x12 Stainless Steel Pin - 2 pcs

Installation and tuning role: these hubs fit the AXIAL SCX10 II wheel/axle interfaces as an aftermarket replacement to alter track width and wheel stance. When installed, they function both as a structural mounting point to transfer wheel loads and as a tuning accessory to balance cornering and climbing behaviour; confirm fit on your wheel hex and axle before final assembly.