AXIAL SCX10 II Aluminium Wheel Hex Claw +3mm with Brake Disk by GPM SCX2006/DISK  [SCX2006/DISK]

Aluminium hex claw for SCX10 II

This RC-scale wheel hex claw set is produced for Axial SCX-10 II platforms and is supplied as a 2pcs set for wheel hubs. It is presented as an aluminium front/rear hex claw with an integrated brake-disk style outline and a 3mm extension to the hex offset.

Functionally the claw is intended to improve how the wheel assembly engages the hub under wheel spin by providing a claw-style interface that can better "grab" and hold the wheel and tyre during low-traction moments. The noted 3mm widening increases the wheel track relative to the suspension mounting, which can increase steadiness on uneven RC terrain.

The brake disk engraving is described as an outline cut that reduces the mass of the disk element, contributing to a marginal weight change at the hub assembly without altering the listed material intent of aluminium. This component is an aftermarket RC part meant for scale trail and rock-crawling setups.

Use this set when you need a modest track widening and a claw-style hex interface on SCX-10 II Jeep Cherokee AX90046 platforms, note that installation and fit should be verified against your hub hardware before final assembly.