AXIAL SCX10 II Hard Steel Transmission Gear by GPM SSCX27038BG  [SSCX27038BG]

Hard steel transmission gear for SCX10 II

This aftermarket transmission gear set is an RC-scale replacement designed for AXIAL SCX10 II drivetrains. Supplied as a single set, the unit uses hard steel for the gear components and is intended for use where a tougher material option is required compared with common stock plastic gears. The description focuses on compatibility, installation considerations, and its tuning role within scale trail and rock crawling setups.

Compatibility: the part is intended for AXIAL SCX10 II platforms and related drivetrains that accept the same transmission gear form factor. Before purchase, confirm your chassis accepts the same transmission gear layout and mounting locations.

Installation notes: remove the gearbox cover and inspect existing gear mesh and bearings before swapping gears. Clean mating surfaces and check for burrs on shafts. Fit the hard steel gears with the original shims or spacing, adjust gear mesh to eliminate binding while maintaining firm engagement, and use an appropriate light gear grease intended for metal gears. After installation, verify smooth rotation by hand and check driveline alignment prior to powered runs.

Tuning role: as a hardened-steel option, this gear set is intended to increase resistance to wear and to handle higher repetitive loads common in slow-speed technical crawling and trail use. It is suitable for hobbyists seeking a durable replacement part for routine maintenance or incremental driveline upgrades, while maintaining scale drivetrain behavior.

This GPM SSCX27038BG gear set provides a hardened-steel option for AXIAL SCX10 II drivetrains, intended for durable replacement or targeted upgrades in scale trail and rock crawling models.