AXIAL SCX10 III Jeep CJ-7 12mm Hex Wheel Adapter +3mm by GPM SCJ010/+3M  [SCJ010/+3M]

12mm hex wheel adapter for SCX10 III

This 12mm hex wheel adapter set is an aftermarket replacement made for AXIAL SCX10 III Jeep CJ-7 use, produced by GPM (SCJ010/+3M). Machined from aluminum 6061, the adapters extend the wheel mounting by +3mm to widen the track and reduce gap between wheel and body. The result is improved lateral stability and a slightly broader stance for slow-speed rock crawling and trail running.

The parts are engineered to directly replace the stock AXIAL SCX10 III hex adapters and retain the 12mm hex interface. The widened design is intended to change wheel position without modifying hubs or axle geometry, making it a straightforward hop-up for tuning roll center and track width on the CJ-7 crawler chassis.

Included hardware from the source package lists the adapters and mating screws, with the pack showing 12mm hex adapter pieces and stainless steel screw shafts; users should verify screw fitment (M3.5x2x11.8 style) before installation. Typical installation requires removing the wheel and stock hex, sliding the adapter onto the axle hex, and securing with the supplied screws using an appropriate hex driver.